Woodshop 51503

Latest Projects

Home
Latest Projects
Shop Tour
Links-N-Things
Box Gallery
Pen Gallery
Misc. Turnings Gallery
My Carving Website

A quick and easy turning project. I took a cheap handled scratch awl and removed the crappy handle and turned one from rosewood and topped it off with a hand rubbed oil finish. Quick and easy lathe project for the shop and great gifts for your wood worker friends.

scratchawl1.jpg
Custom Turned Scratch Awl

My most recent project are these newly completed pen boxes made from Cherry. Finish is rubbed out oil poly.

cherrypenbox1.jpg
Single Pen Box

Pen Boxes

Decided to make some pens and pen boxes for executive Christmas gifts. Here are some photos of the boxes and a few of the process of making them.

Template holder for holding the box part for plunge routing.

penbox1.jpg

Photo of the template.

penbox2.jpg

1 inch guide bushing used with 5/8 inch dish cutter.

penbox3.jpg

Blocking added to template holder to hold the stock. The Template will sit on top of that.

penbox4.jpg

Template in place ready to route.

penbox5.jpg

One groove routed in pen box.

penbox6.jpg

Finished bottoms of the cases.

penbox7.jpg

Finished top and bottom

penbox10.jpg

Finished Pen boxes. Walnut bottoms and maple tops. One with round overs all over and 2 with round overs on the top and bottom. Finished with poly and rubbed out.

penbox35.jpg

penbox37.jpg

penbox39.jpg

Router Carvings and Inlays

I recently became interested in using the router to do carvings and inlays on boxes using the router. A key to this is a fixture called a template holder. The template holder can hold a work piece to be routed with blocking and packing which holds the work piece firm while routing. The template sits on top and the hand held plunge router is used to to complete the work.

This method has been used by Template Tom of Australia who specializes in plunge routing with templates, guides and router skis and Bob and Rick of the Router Workshops who sell their own jig. See the link below for more info on this. The system works great.

I made mine without the cams that hold the work piece, mainly to keep it simpler. I also built mine to specifically fit the Spirocrafter from Milescraft. This is a great jig.

Below are some photos of the jig and some box lids that I produced with it.

The Router Workshop

Introduction To Template Guides

Making An Inlay

What follows is a step by step of making a box lid with an inlay. The work piece was held in the jig holder and then the template was added and trapped on top. First the inlay cavity is created and then the inlay itself is created.

inlay1.jpg

inlay2.jpg

inlay3.jpg

Routing out the inlay itself.

inlay6.jpg

The inlay inserted into the cavity, soon to be a box lid.

inlay7.jpg

inlay9.jpg

Here is the basic jig itself.

templatejigholder1.jpg

The Spirocrafter In The Template Holder

spirocrafter1.jpg

Items Created With The Jig Holder and Spiro Crafter

spiro9.jpg

spiro8.jpg

spiro4.jpg

Enter content here

Enter supporting content here